HP0-Y52 試験問題を無料オンラインアクセス

Refer to the Exhibit.
Exhibit: HP Comware switch configuration.
[Comware] vlan 100 [Comware-vlan100] quit [Comware] vlan 200 [Comware-vlan200] quit [Comware] interface g1/0/22 [Comware-GigabitEthernet1/0/22] port link-type trunk [Comware-GigabitEthernet1/0/22] port trunk permit vlan 100 200 [Comware-GigabitEthernet1/0/22] quit
A network administrator configures the Comware switch, as shown in the exhibit. The network administrator then connects a cable from the Comware's g1/0/22 interface to port 5 on an HP ProVision switch. Which configuration will successfully establish connection for VLAN 1, 100, and 200 between the two switches?

• A.ProVision (config) # vlan 100 ProVision (config) # vlan 200 ProVision (config) # interface 5 tagged 100 ProVision (config) # interface 5 tagged 200
• B.ProVision (config) # vlan 100 ProVision (config) # vlan 200 ProVision (config) # interface 5 tagged 100 200
• C.ProVision (config) # vlan 100 ProVision (config) # vlan 200 ProVision (config) # vlan 100 tagged 5 ProVision (config) # vlan 200 tagged 5
• D.ProVision (config) # vlan 100 200 ProVision (config) # vlan 100 200 tagged 5

What is the purpose of a management VLAN on an HP Provision switch?

• A.To limit remote access connections by specifying the IP addresses that can establish connections
• B.To identify a specific VLAN as the only VLAN from which users can connect to the switch management interface
• C.To prevent IP addresses from being configured on any VLANs other than the management VLAN
• D.To provide an administrative-only marker, label, or alias for the VLAN where IMC is installed

An HP ProVision switch is operating at its factory default settings. A network administrator connects the switch to a VLAN with a DHCP server. The switch-to-switch connection is carrying untagged traffic. The administrator wants to log in to the switch CLI using Telnet.
How should the administrator contact the switch and log in?

• A.Contact the switch at its DHCP-assigned IP address and log in without entering a password.
• B.Contact the switch at its default IP address 192.168.1.1/24 and log in without entering a password.
• C.Contact the switch at its DHCP-assigned IP address and log in with the default password hp.
• D.Contact the switch at its default IP address 192.168.1.1/24 and log in with the default password hp .

Refer to the exhibit.

Based on the topology shown in the exhibit, which symptom does a network administrator see if
the HP switches are in their factory default states?

• A.Layer 3 loop
• B.Mislearned MAC addresses
• C.Multiple ARP requests
• D.Unicast storms

Which credential is required to validate SNMPv2c write requests?

• A.MD5 authkey
• B.Community string
• C.Scheme
• D.AAA authentication