HP0-Y43 試験問題を無料オンラインアクセス

A network administrator is deploying HP 5800 switches at the access layer and wants to manage them with HP Intelligent Management Center (IMC). When SNMP is enabled on these switches, which version of SNMP is implemented by default?

• A.SNMP version 2c with backward compatibility with version 1
• B.SNMP version 1
• C.SNMP version 3
• D.SNMP version 2c

View the exhibit.

The exhibit shows a network with HP 5400 zl and 8200 zl switches throughout the core and edge. What is one advantage of implementing routing on edge switches?

• A.The topology has higher redundancy because edge switches can take over routing roles when necessary.
• B.Typically, it is easier to implement user-based VLAN assignments.
• C.Typically, it is easier to ensure that routed links between edge and core switches are fully utilized.
• D.Typically, the network can use fewer total VLANs when edge switches implement routing.

View the exhibit.

A network administrator configures the HP 2610-24-PoE switch as shown in the exhibit. Computers belong to the data VLAN, which is VLAN 10. IP phones should transmit traffic on VLAN 20. They should be able to connect to any port and use LLDP-MED to obtain their VLAN assignment. However, IP phones connected to this switch cannot reach the VoIP server and are not functioning correctly. IP phones connected to other switches are functioning correctly. What must the network administrator do?

• A.Enable LLDP-MED globally.
• B.Enable LLDP-MED on the ports into which phones are connected.
• C.Make VLAN 20 untagged on the ports into which phones are connected.
• D.Define VLAN 20 as a voice VLAN.

A network administrator enabled IPv6 on an HP 7500 switch and configured VLAN interface 10 with a link-local and global IPv6 address 2001:DB8:1:10::1/64. The network administrator now wants IPv6-capable endpoints connected to VU\N 10 to receive IPv6 addresses using stateless autoconfiguration. Which step must the network administrator complete on the 7500 switch?

• A.Set the managed configuration flag in RA messages.
• B.Re-enable RA messages on VLAN interface 10.
• C.Configure DHCPv6 relay on VLAN interface 10.
• D.Configure the VLAN 10 interface to advertise prefix 2001:DB8:1:10::/64.

Which security protocol requires the servers to use digital certificates?

• A.AH and ESP for HTTP traffic
• B.SSH for console sessions
• C.Telnet for console sessions
• D.SSL and TLS for HTTP traffic