HP0-M51 試験問題を無料オンラインアクセス

How can you verify the number of discovered elements with NNMi?

• A.Run the ovstatus -nodes -info command.
• B.Select Node > number of discovered elements.
• C.Select Report > number of discovered elements.
• D.Select Help > About HP Network Node Manager i software.

Using Global and Regional Managers, how can you view device status and incidents for important devices located at multiple locations?

• A.Set up web services on the Regional Managers so they only forward information about critical devices to the Global Manager.
• B.Set up Northbound Integration to forward information about critical devices to the Global Manager.
• C.Set up forwarding filters on the Regional Managers so they only forward information about important devices to the Global Manager.
• D.Set forwarding of critical devices by editing the globall.properties and regionall.properties files.

Which method is used to view the results of a Diagnostic Report?

• A.Open the Troubleshooting workspace and choose Diagnostics.
• B.Select the desired node, right-click, and choose Diagnostic Report.
• C.Open the Inventory workspace, select Nodes, and click Diagnostic Report.
• D.Open the desired node, click the Diagnostics tab, and click the report number.

The SNMP community string was changed on a device. At the next NNMi status poll, how does NNMi report on this device when the Enable SNMP Address Rediscovery check box is cleared?

• A.Down and does not attempt to find another Communication Configuration setting for that device
• B.NOSNMP but attempts to find another Communication Configuration setting for that device
• C.NOSNMP and does not attempt to find another Communication Configuration setting for that device
• D.Down but attempts to find another Communication Configuration setting for that device

How can you create a Node Group? (Select two.)

• A.Go to Configuration workspace > select User Interface Configuration > select Node Group Map settings > select New.
• B.Create a CSV file with required format and use the nnmloadnodegroups.ovpl command.
• C.Go to Configuration workspace > select Node Groups > select New.
• D.Go to Topology Maps workspace > select Actions > select Node Group Settings > select New.
• E.Go to Configuration workspace > select Node Groups > select Actions > select New.