NSE8_812 試験問題を無料オンラインアクセス

Refer to the exhibits.

A customer has deployed a FortiGate with iBGP and eBGP routing enabled. HQ is receiving routes over eBGP from ISP 2; however, only certain routes are showing up in the routing table-Assume that BGP is working perfectly and that the only possible modifications to the routing table are solely due to the prefix list that is applied on HQ.
Given the exhibits, which two routes will be active in the routing table on the HQ firewall? (Choose two.)

• A.172,620,64,27
• B.172.16.201.96/29
• C.172.16.204.128/25
• D.172.16.204.64/27

You are troubleshooting a FortiMail Cloud service integrated with Office 365 where outgoing emails are not reaching the recipients' mail What are two possible reasons for this problem? (Choose two.)

• A.The FortiMail access control rules to relay from Office 365 servers public IPs are missing.
• B.The FortiMail DKIM key was not set using the Auto Generation option.
• C.A Mail Flow connector from the Exchange Admin Center has not been set properly to the FortiMail Cloud FQDN.
• D.The FortiMail access control rule to relay from Office 365 servers FQDN is missing.

Refer to the exhibit showing the history logs from a FortiMail device.

Which FortiMail email security feature can an administrator enable to treat these emails as spam?

• A.Soft fail SPF validation in an antispam profile
• B.Impersonation analysis in an antispam profile
• C.DKIM validation in a session profile
• D.Sender domain validation in a session profile

You must analyze an event that happened at 20:37 UTC. One log relevant to the event is extracted from FortiGate logs:

The devices and the administrator are all located in different time zones Daylight savings time (DST) is disabled
* The FortiGate is at GMT-1000.
* The FortiAnalyzer is at GMT-0800
* Your browser local time zone is at GMT-03.00
You want to review this log on FortiAnalyzer GUI, what time should you use as a filter?

• A.12.37:08
• B.17:37:08
• C.20:37:08
• D.10:37:08

Refer to the exhibit.

You have been tasked with replacing the managed switch Forti Switch 2 shown in the topology.
Which two actions are correct regarding the replacement process? (Choose two.)

• A.After replacing the FortiSwitch unit, the automatically created trunk name changes.
• B.MCLAG-ICL will be automatically reconfigured once the new switch is connected to the FortiGate.
• C.After replacing the FortiSwitch unit, the automatically created trunk name does not change
• D.CLAG-ICL needs to be manually reconfigured once the new switch is connected to the FortiGate