NSE8_810 試験問題を無料オンラインアクセス

Click the Exhibit button.
What are two ways to establish communication between an existing NAT VDOM and a new transparent VDOM? (Choose two.)

• A.Set the not ip 10.I0.I0.1 command to vlink20.
• B.Set the set ip 10.10.10. i command to vlink2l.
• C.Set type ppp to the vdom-link, vlink2.
• D.Set type ethernet to the vdom-link, vlink2.

FortiMail configured with the protected domain "internal lab".
Which two envelopes addresses will need an access control rule to relay e-mail sent for unauthenticated users?
(Choose two.)

• A.MAIL FROM: trainmg@internallab; RCPT TO student@mternallab
• B.MAIL FROM: traming@fortinet com: RCPT TO: student@fortmet com
• C.MAIL FROM student@internal lab: RCPT TO [email protected]
• D.MAIL FROM student@fortinet com: RCPT TO [email protected]

Exhibit
Click the Exhibit button. Referring to the exhibit, which two behaviors will the FortiClient endpoint have after receiving the profile update from the FortiClient EMS? (Choose two.)

• A.The user will not be able to access a Web downloaded file for at least 60 seconds when the FortiSandbox is reachable.
• B.The user will not be able to access a Web downloaded file when the FortiSandbox is unreachable.
• C.The user will not be able to access a Web downloaded file for a maximum of 60 seconds if it is not a virus and the FortiSandbox s reachable.
• D.Files executed from a mapped network drive will not be inspected by the FortiCltent endpoint Antivirus engine.

Exhibit
Click the Exhibit button.
The exhibit shows the configuration of a service protection profile (SPP) in a FortiDDoS device.
Which two statements are true about the traffic matching being inspected by this SPP? (Choose two.)

• A.FortiDDos will not send a SYNACK if a SYN packet is coming from an IP address that is not the legtimate IP (LIP) address table.
• B.FortiDooS will start dropping packets as soon as the traffic executed the configured maintain threshold.
• C.Traffic that does match any spp policy will not be inspection by this spp.
• D.SYN packets with payloads will be drooped.

Click the exhibit.
You created an aggregate interface between your FortiGate and a switch consisting of two 1 Gbps links as shown in the exhibit. However, the maximum bandwidth never exceeds. 1 Gbps and employees are complaining that the network is slow. After troubleshooting, you notice only one member interface is being used. The configuration for the aggregate interface is shown in the exhibit.
In this scenario, which command will solve this problem?

• A.config system interface
  edit Agg1
  set lacp-mode active
  end
• B.config system interface
  edit Agg1
  set weight 2
  end
• C.config system interface
  edit Agg1
  set Algorithm L4
  end
• D.config system interface
  edit Agg1
  set min-links 2
  end