NSE7_SSE_AR-26 試験問題を無料オンラインアクセス

Refer to the exhibit. The exhibit shows output of the command diagnose sys sdwan service4 collected on a FortiGate device. The administrator wants to know through which interface FortiGate will steer traffic from local users on subnet 10.0.1.0/255.255.255.192 and with a destination of the social media application Facebook. Based on the exhibits, which two statements are correct? (Choose two.)

Exhibit 1

• A.FortiGate steers traffic for social media applications according to the service rule 2 and steers traffic through port2.
• B.When FortiGate cannot recognize the application of the flow, it steers the traffic through the preferred member of rule 3, HQ_T1.
• C.There is no service defined for the Facebook application, so FortiGate appliesservice rule 3 and directs the traffic to headquarters.
• D.When FortiGate cannot recognize the application of the flow, it load balances the traffic through the tunnels HQ_T1. HQ_T2. HQ_T3.

Refer to the exhibits. You connect to a device behind a branch FortiGate device and initiate a ping test. The device is part of the LAN subnet and its IP address is 10.0.1.101. Based on the exhibits, which interface uses branch 1_fgt to steer the test traffic?

Exhibit 1

• A.HUB1-VPN1
• B.port4
• C.port2
• D.port1

Refer to the exhibit.
Two hub-and-spoke groups are connected through redundant site-to-site IPsec VPNs between Hub 1 and Hub
2.
Which two configuration settings are required for spoke A1 to establish an auto-discovery VPN (ADVPN) shortcut with spoke B2? (Choose two.)

Exhibit - Hub-and-spoke ADVPN topology

• A.On the hubs, auto-discovery-forwarder must be enabled on the IPsec VPNs to hubs.
• B.On the spokes, auto-discovery-receiver must be enabled on the IPsec VPNs to the hub.
• C.On the hubs, auto-discovery-receiver must be enabled on the IPsec VPNs to spokes.
• D.On the spokes, auto-discovery-sender must be enabled on the IPsec VPNs to hubs.

In the context of SD-WAN, the terms underlay and overlay are commonly used to categorize links.
Which two statements about underlay and overlay links are correct? (Choose two.)

• A.A VLAN is a type of overlay link.
• B.FortiLink interface is considered a underlay link.
• C.Only wired connections can be used as underlay links.
• D.Overlay links provide routing flexibility.
• E.Wireless connections can be used to build overlay links.

Refer to the exhibits. You use FortiManager to configure SD-WAN on three branch devices. When you install the device settings. FortiManager prompts you with the error " Copy Failed " for the device branch1_fat When you click the log button. FortiManager displays the message shown in the exhibit.

Exhibit 1

• A.Remove the installation target for the SD-WAN member port4. You cannot combine metadata variable and installation targets.
• B.Based on the exhibits, which statement best describes the issue and how you can resolve it?
• C.Gateways for all members in a zone must be defined the same way. Specify the gateway of the SD- WAN member port! without metadata variables.
• D.Check the connection between branch1_fgt and FortiManager