NSE7_SDW-6.4 試験問題を無料オンラインアクセス

Which statement defines how a per-IP traffic shaper of 10 Mbps is applied to the entire network?

• A.The 10 Mbps bandwidth is shared equally among the IP addresses.
• B.Each IP is guaranteed a minimum 10 Mbps of bandwidth
• C.FortiGate allocates each IP address a maximum 10 Mbps of bandwidth.
• D.A single user uses the allocated bandwidth divided by total number of users.

Which two configuration tasks are required to use SD-WAN? (Choose two.)

• A.Configure at least one firewall policy for SD-WAN traffic.
• B.Add one or more members to an SD-WAN zone.
• C.Specify the incoming interfaces in SD-WAN rules.
• D.Specify the outgoing interface routing cost.

What are two reasons why FortiGate would be unable to complete the zero-touch provisioning process? (Choose two.)

• A.The zero-touch provisioning process has completed internally, behind FortiGate.
• B.A factory reset performed on FortiGate.
• C.FortiGate has obtained a configuration from the platform template in FortiGate cloud.
• D.The FortiGate cloud key has not been added to the FortiGate cloud portal.
• E.FortiDeploy has connected with FortiGate and provided the initial configuration to contact FortiManager

Refer to the exhibit.

Which two statements about the IPsec VPN configuration and the status of the IPsec VPN tunnel are true? (Choose two.)

• A.FortiGate creates separate virtual interfaces for each dial-up client.
• B.FortiGate creates a single IPsec virtual interface that is shared by all clients.
• C.FortiGate maps the remote gateway 100.64.3.1 to tunnel index interface 1.
• D.FortiGate does not install IPsec static routes for remote protected networks in the routing table.

Refer to the exhibit.

Which two statements about the debug output are true? (Choose two)

• A.This traffic shaper drops traffic that exceeds the set limits.
• B.FortiGate provides statistics and reading based on historical traffic logs.
• C.Traffic being controlled by the traffic shaper is under 100 KB/s.
• D.The debug output shows per-IP shaper values and real-time readings.