NSE6_FNC_AD-7.6 試験問題を無料オンラインアクセス

In a wireless integration, what method does FortiNAC use to obtain connecting MAC address information?

• A.RADIUS
• B.Endstation traffic monitoring
• C.SNMP traps
• D.Link traps

Refer to the exhibit. An administrator has configured the DHCP scope for a registration isolation network, but the isolation process isn't working.
What is the problem with the configuration?

• A.The domain name server designation is incorrect.
• B.The lease pool does not contain a complete subnet.
• C.The label uses a system-reserved value.
• D.The gateway defined for the scope is incorrect.

When configuring isolation networks in the configuration wizard, why does a layer 3 network type allow for more than one DHCP scope for each isolation network type?

• A.Any scopes beyond the first scope are used if the initial scope runs out of IP addresses.
• B.The layer 3 network type allows for one scope for each possible host status.
• C.Configuring more than one DHCP scope allows for DHCP server redundancy
• D.There can be more than one isolation network of each type

When FortiNAC-F is managing VPN clients connecting through FortiGate, why must the clients run a FortiNAC-F agent?

• A.To validate the endpoint policy compliance
• B.To collect the client IP address and MAC address
• C.To collect user authentication details
• D.To transparently update The client IP address upon successful authentication

Two FortiNAC-F devices have been configured in a 1+1 active-passive HA configuration. Which condition would cause the primary FortiNAC-F to shut down the NAC process and change the management status to down?

• A.The secondary takes control of the primary.
• B.The primary misses five heartbeats and fails to ping the gateway.
• C.The primary fails to poll the secondary while the gateway responds successfully.
• D.An administrator changes the status of the secondary to Running ?In Control.