NSE6_FNC-9.1 試験問題を無料オンラインアクセス

Where do you look to determine which network access policy, if any is being applied to a particular host?

• A.The Port Properties view of the hosts port
• B.The Connections view
• C.The Policy Logs view
• D.The Policy Details view for the host

Refer to the exhibit.

What would happen if the highlighted port with connected hosts was placed in both the Forced Registration and Forced Remediation port groups?

• A.Multiple enforcement groups could not contain the same port.
• B.Both types of enforcement would be applied.
• C.Enforcement would be applied only to rogue hosts.
• D.Only the higher ranked enforcement group would be applied.

What would occur if both an unknown (rogue) device and a known (trusted) device simultaneously appeared on a port that is a member of the Forced Registration port group?

• A.The port would be administratively shut down.
• B.The port would be provisioned for the normal state host, and both hosts would have access to that VLAN.
• C.The port would not be managed, and an event would be generated.
• D.The port would be provisioned to the registration network, and both hosts would be isolated.

With enforcement for network access policies and at-risk hosts enabled, what will happen if a host matches a network access policy and has a state of "at risk"?

• A.The host is provisioned based on the default access defined by the point of connection.
• B.The host is provisioned based on the network access policy.
• C.The host is isolated.
• D.The host is administratively disabled.

Where are logical network values defined?

• A.In the model configuration view of each infrastructure device
• B.In the port properties view of each port
• C.On the profiled devices view
• D.In the security and access field of each host record