NSE6_FMG_AD-7.6 試験問題を無料オンラインアクセス

What are two outcomes of ADOM revisions? Choose two answers.

• A.ADOM revisions can save the current state of all policy packages and objects for an ADOM.
• B.ADOM revisions do not increase the size of configuration backups.
• C.ADOM revisions can save the current state of the entire ADOM.
• D.ADOM revisions appear in the Install Policy and Package Settings section of the install wizard.

Refer to the exhibit.

An administrator has assigned the default system template to install all devices with the FortiAnalyzer IP address 10.0.13.12. However, not all FortiGate devices can reach FortiAnalyzer using the default interface.
Some devices may use the LAN interface, while others may use the WAN interface. How can the administrator change the source interface for FortiGate devices using the default system template? Choose one answer

• A.Use per-device dynamic object configurations at the ADOM level and apply them in the template.
• B.Create a meta field on FortiManager system settings of type Device and use it in the template.
• C.Configure a metadata variable at the ADOM level and use it in the template.
• D.Create a different system template for each FortiGate, if the configuration is different.

Refer to the exhibits.


Which IP/netmask will be present in the LAN firewall address object on the Remote-Firewall?

• A.172.16.0.0/255.255.255.0
• B.172.16.10.0/255.255.255.0
• C.192.168.1.0/255.255.255.0
• D.10.0.0.0/255.255.255.0

Refer to the following configuration. FortiManager # config system global global# set workspace-mode normal global# end FortiManager # What are two results from the configuration shown in the exhibit? Choose two answers

• A.All changes must be approved before they can be installed on a device.
• B.Multiple administrators can lock and work on separate ADOMs at the same time.
• C.Concurrent read-write access to an ADOM is disabled.
• D.The same administrator can lock more than one ADOM at the same time.

The administrator uses FortiManager to push a CLI script using the Remote FortiGate Directly (via CLI) option to configure an IPsec VPN. However, when running the script, the administrator receives the following error:
config vpn ipsec phase2-interface [parameter(s) invalid. detail: object mismatch] What must the administrator do to resolve the script error and successfully apply the IPsec configuration?

• A.Add the end command after finishing the IPsec phase 1-interface configuration block.
• B.Run the script using the policy package or ADOM database method.
• C.Use IPsec templates to deploy provisioning templates.
• D.Add a second config vpn ipsec phase2-interface block without linking it to phase1.