NSE5_SSE_AD-7.6 試験問題を無料オンラインアクセス

An SD-WAN member is no longer used to steer SD-WAN traffic. You want to update the SD-WAN configuration and delete the unused member.
Which action should you take first? (Choose one answer)

• A.Disable the interface.
• B.Move the SD-WAN member to the virtual-wan-link zone.
• C.Remove the member from the performance service-level agreement (SLA) definitions.
• D.Delete static route definitions for that interface.

How does the FortiSASE security dashboard facilitate vulnerability management for FortiClient endpoints?
(Choose one answer)

• A.It shows vulnerabilities only for applications and requires endpoint users to manually check for affected endpoints.
• B.It provides a vulnerability summary, identifies affected endpoints, and supports automatic patching for eligible vulnerabilities.
• C.It automatically patches all vulnerabilities without user intervention and does not categorize vulnerabilities by severity.
• D.It displays only critical vulnerabilities, requires manual patching for all endpoints, and does not allow viewing of affected endpoints.

Refer to the exhibit.

The SD-WAN rule status and configuration is shown. Based on the exhibit, which change in the measured latency will first make HUB1-VPN3 the new preferred member?

• A.When HUB1-VPN3 has a lower latency than HUB1-VPN1 and HUB1-VPN2
• B.When HUB1-VPN1 has a latency of 200 ms
• C.When HUB1-VPN3 has a latency of 80 ms
• D.When HUB1-VPN3 has a latency of 90 ms

Which statement is true about FortiSASE supported deployment?

• A.FortiSASE supports VPN mode and Agentless mode, based on user requirements.
• B.FortiSASE relies on ZTNA-only mode, which replaces SWG and endpoint functions.
• C.FortiSASE operates only in SWG mode, where all traffic is forced through FortiSASE POPs.
• D.FortiSASE supports both Endpoint mode and SWG mode, depending on deployment.

Which statement is true about scheduling a FortiClient upgrade using an endpoint upgrade rule?

• A.An endpoint upgrade rule can be assigned to a user group.
• B.When scheduled, the installation always starts immediately if the endpoint is online.
• C.If the scheduled time is already past in the local time zone of the endpoint, installation starts the next day at that time.
• D.Scheduled upgrades automatically reboot macOS endpoints after installation.