NSE5_FMG-5.4 試験問題を無料オンラインアクセス

Refer to the following exhibit:

Which of the following statements are true based on this configuration? (Choose two.)

• A.Unlocking an ADOM will submit configuration changes automatically to the approval administrator.
• B.The same administrator can lock more than one ADOM at the same time.
• C.Ungraceful closed sessions will keep the ADOM in a locked state until the administrator session times out.
• D.Unlocking an ADOM will install configuration changes automatically on managed devices.

An administrator has enabled Service Access on FortiManager. What is the purpose of Service Access on the FortiManager interface?

• A.Allows FortiManager to download IPS packages.
• B.Allows Formanager to respond for FortiGround services from FortiGate devices.
• C.Allows Formanager to automatically configure a default mode.
• D.Allows ForManager to run real-time debugs on the managed devices.

When installation is performed from the FortiManager, what is the recovery logic used between FortiManager and FortiGate for an FGFM tunnel?

• A.FortiManager will revert and install a previous configuration revision on the managed FortiGate.
• B.FortiGate will reject the CLI commands that will cause the tunnel to go down.
• C.After 15 minutes, FortiGate will unset all CLI commands that were part of the installation that caused the tunnel to go down.
• D.FortiManager will not push the CLI commands as a part of the installation that will cause the tunnel to go down.

Which of the following statements are true regarding VPN Gateway configuration in VPN Manager? (Choose two.)

• A.Protected subnets are the subnets behind the device that you don't want to allow access to over the IPsec VPN
• B.Managed gateways are devices managed by FortiManager in the same ADOM
• C.External gateways are third-party VPN gateway devices only
• D.Managed devices in other ADOMs must be treated as external gateways

What is the purpose of the ADOM revision?

• A.To crease System policy packages and device-level settings for a managed Fortigate by reverting to a specific ADOM revision.
• B.To create System Checkpoint for the FortiManager configuration.
• C.To save the current state of all policy packages and objects for an ADOM.
• D.To save the current state of the whole ADOM.