FCSS_NST_SE-7.6 試験問題を無料オンラインアクセス

Which Iwo actions does FortiGate take after an administrator enables the auxiliary session selling? (Choose two.)

• A.FortiGate creates two sessions in case of a routing change.
• B.FortiGate accelerates all ECMP traffic to the NP6 processor
• C.FortiGates creates a now auxiliary session for each packet it receives.
• D.FortiGate only offloads auxiliary sessions.

Refer to the exhibit, which shows a partial output of the real-time LDAP debug.

What two actions can the administrator take to resolve this issue? (Choose two.)

• A.Ensure the user is providing the correct user credentials.
• B.Ensure the user is a member of at least one AD group to ensure step 4 of the LDAP authentication process is successful.
• C.Ensure the account is active.
• D.Ensure the user logs in using ' John Smith ' not ' jsmith ' .

Exhibit 1.

Exhibit 2.

Refer to the exhibits, which show the configuration on FortiGate and partial internet session information from a user on the internal network.
An administrator would like to lest session failover between the two service provider connections.
Which two changes must the administrator make to force this existing session to immediately start using the other interface? (Choose two.)

• A.Configure set snat-route-change enable.
• B.Change the priority of the port2 static route to 5.
• C.Change the priority of the port1 static route to 11.
• D.Configure unset snat-route-change to return it to the default setting.

Which two statements about an auxiliary session ate true? (Choose two.)

• A.With the auxiliary session setting enabled. Iwo sessions are created in case of routing change.
• B.With the auxiliary session selling disabled, only auxiliary sessions are offloaded.
• C.With the auxiliary session setting enabled. ECMP traffic is accelerated to the NP6 processor.
• D.With the auxiliary session setting disabled, for each traffic path. FortiGate uses the same auxiliary session.

Which two statements about application-layer test commands are true? (Choose two answers)

• A.Some of them display real-time application debugs.
• B.Some of them display output only after you run the diagnose debug console enable command.
• C.Some of them can be used to restart an application.
• D.Some of them display statistics and configuration information about a feature or process.