FCSS_EFW_AD-7.6 試験問題を無料オンラインアクセス

Refer to the exhibit, which shows an OSPF network.

Which configuration must the administrator apply to optimize the OSPF database?

• A.Set an access list in the AS boundary FortiGate.
• B.Set the area 0.0.0.1 to the type STUB in the area border FortiGate.
• C.Set the area 0.0.0.1 to the type NSSA in the area border FortiGate.
• D.Set a route map in the AS boundary FortiGate.

Refer to the exhibit, which contains the partial output of an OSPF command.

An administrator is checking the OSPF status of a FortiGate device and receives the output shown in the exhibit.
Which statement on this FortiGate device is correct?

• A.The FortiGate device is in the area 0.0.0.5.
• B.The FortiGate device is a backup designated router.
• C.The FortiGate device can inject external routing information.
• D.The FortiGate device does not support OSPF ECMP.

Why does FortiGate_B install only one OSPF external route?

• A.Route filtering
• B.Single advertisement
• C.Area mismatch
• D.ECMP disabled

Refer to the exhibit, which shows an ADVPN network.

The client behind Spoke-1 generates traffic to the device located behind Spoke-2. What is the first message that the hub sends to Spoke-1 to bring up the dynamic tunnel?

• A.Shortcut reply
• B.Shortcut query
• C.Shortcut forward
• D.Shortcut offer

While configuring the BGP protocol, an administrator applies the set network-import-check disable command under config network.
What will FortiGate do as a result of this command?

• A.FortiGate will advertise all the prefixes in the BGP network table to its BGP neighbor, even if it is not in the routing table.
• B.FortiGate will not advertise any imported routes received from one BGP neighbor to another.
• C.FortiGate will not advertise the prefixes, if it is not in the routing table.
• D.FortiGate will advertise only the corresponding prefixes in the BGP network table to its BGP neighbor, even if it is not in the routing table.