FCNSP 試験問題を無料オンラインアクセス

Which of the following statements are TRUE for Port Pairing and Forwarding Domains? (Select all that apply.)

• A.They are only available in high-end models.
• B.Port Pairing works only for physical interfaces.
• C.They may contain physical and/or virtual interfaces.
• D.They both create separate broadcast domains.
• E.Forwarding Domains only apply to virtual interfaces.

Select the answer that describes what the CLI command diag debug authd fsso list is used for.

• A.Displays which users are currently logged on using FSSO.
• B.Displays a listing of all connected FSSO Collector Agents.
• C.Monitors communications between the FSSO Collector Agent and FortiGate unit.
• D.Lists all DC Agents installed on all Domain Controllers.

Review the output of the command config router ospf shown in the Exhibit below; then answer the
question following it.

Which one of the following statements is correct regarding this output?

• A.OSPF Hello packets will be sent on all interfaces configured with an address matching the 10.0.1.0/24 and 172.16.0.0/12 networks.
• B.OSPF Hello packets will be sent on all interfaces of the FortiGate device.
• C.OSPF Hello packets are not sent on point-to-point networks.
• D.OSPF Hello packets will only be sent on interfaces configured with the IP addresses 172.16.1.1 and 172.16.1.2.

An administrator wishes to generate a report showing Top Traffic by service type, but wants to exclude SMTP traffic from the report.
Which of the following statements best describes how to do this?

• A.In the Service field of the Data Filter, type 25/smtp and select the NOT checkbox.
• B.When editing the chart, uncheck mlog to indicate that Mail Filtering data is being excluded when generating the chart.
• C.Add the following entry to the Generic Field section of the Data Filter: service="!smtp".
• D.When editing the chart, enter 'dns' in the Exclude Service field.

What advantages are there in using a hub-and-spoke IPSec VPN configuration instead of a fully-meshed set of IPSec tunnels? (Select all that apply.)

• A.Using a hub and spoke topology is required to achieve full redundancy.
• B.Using a hub and spoke topology simplifies configuration.
• C.Using a hub and spoke topology reduces the number of tunnels.
• D.Using a hub and spoke topology provides stronger encryption.