F50-531 試験問題を無料オンラインアクセス

When configuring a pool member's monitor, which three association options are available? (Choose three.)

• A.configure a default monitor
• B.inherit the pool's monitor
• C.assign a monitor to the specific member
• D.do not assign any monitor to the specific member
• E.inherit the node's monitor

When initially configuring the BIG-IP system using the config utility, which two parameters can be set? (Choose two.)

• A.the IP address of the SCCP
• B.the netmask of the SCCP
• C.the port lockdown settings for the SCCP
• D.the netmask of the host via the management port
• E.the IP address of the host via the management port
• F.the port lockdown settings for the host via the management port

A BIG-IP has two load balancing virtual servers at 150.150.10.10:80 and 150.150.10.10:443. The port 80 virtual server has SNAT auto-map configured. There is also a SNAT configured at
150.150.10.11 set for a source address range of 200.200.1.0 / 255.255.255.0. All other settings are at their default states. If a client with the IP address 200.200.1.1 sends a request to https://150.150.10.10, what is the source IP address when the associated packet is sent to the pool member?

• A.Floating self IP address on VLAN where the packet leaves the system
• B.150.150.10.11
• C.200.200.1.1
• D.Floating self IP address on VLAN where the packet arrives on the system

Which statement is true concerning iRule events?

• A.All client traffic has data that could be used to trigger iRule events.
• B.All iRule events are appropriate at any point in the client-server communication.
• C.If an iRule references an event that doesn't occur during the client's communication, the client's connection will be terminated prematurely.
• D.All iRule events relate to HTTP processes.

Which statement accurately describes the difference between two load-balancing modes specified as "member" and "node"?

• A.Load-balancing options referencing "nodes" are available only when the pool members are defined for the "any" port.
• B.When the load-balancing choice references "node", the addresses' parameters are used to make the load-balancing choice rather than the member's parameters.
• C.When the load-balancing choice references "node", priority group activation is unavailable.
• D.There is no difference; the two terms are referenced for backward compatibility purposes.