DES-5121 試験問題を無料オンラインアクセス

Which commands should a network administrator use to configure a RADIUS server on a Dell EMC N-Series switch?

• A.Switch-1(config)# radius 10.1.1.111
  Switch-1(config-radius)# name RADIUS-Server
  Switch-1(config-radius)# key secretkey
• B.Switch-1(config)# radius auth server 10.1.1.111 Switch-1(config-radius)# name RADIUS-Server Switch-1(config-radius)# key "secretKey"
• C.Switch-1(config)# radius server auth 10.1.1.111 Switch-l(config-radius)# name RADIUS-Server Switch-1(config-radius)# key "secretkey"
• D.Switch-1(config)# radius auth 10.1.1.111 Switch-1(config-radius)# name "RADIUS-Server" Switch-1(config-radius)# key "secretKey"

Exhibit:

The exhibit represents a topology with all Dell EMC N4000 Series switches with RSTP enabled. In addition, the switches are using the default configuration on all ports and protocols.
Which port number will be blocked by spanning tree?

• A.Te 1/0/5
• B.Te 1/0/4
• C.Te 1/0/3
• D.Te 1/0/6

What is the typical sequence of steps to upgrade the firmware of a Dell EMC N-Series switch?

正解：

What is a recommended configuration for an MLAG peer-link on a Dell EMC N-Series switch?

• A.Link must contain multiple interfaces
• B.Link must be a trunk port
• C.Spanning tree must be enabled
• D.Spanning tree must be disabled

After setting up the VoIP configuration, a network administrator issues the following commands with the results shown:
console# show voice vlan
Administrative Mode...........................Enable
console# show voice vlan it gi 1/0/2
Interface........................................Gi1/0/2
Voice VLAN Interface Mode...............Enabled
Voice VLAN ID...............................10
Voice VLAN COS Overwrite...............False
Voice VLAN DSCP Value...................46
Voice VLAN Port Status.....................Enabled
Voice VLAN Authentication................Disabled
Based on this information, what is the Layer 3 QoS value?

• A.46
• B.10
• C.Gi1/0/2
• D.5