DES-1721 試験問題を無料オンラインアクセス

Based on the exhibit, a customer is using a Virtual Port Mode configuration. If the cable for Domain 1 on Controller 1 is disconnected during failover testing, will the SC Series array port failover work?

• A.No, the configuration contains only a single port per domain and will not provide port failover.
• B.Yes, the configuration will provide port failover regardless of domains or mode.
• C.Yes, the configuration will provide port failover as the system is configured for Virtual Port Mode.
• D.No, port failover only works in Legacy Port Mode.

What is the correct sequence of steps to enable MPIO on a Microsoft Windows 2012 Server?

正解：

When an RS-232 serial cable is connected between a service laptop and SC Series hardware, which parameters need to be selected?

• A.Baud Rate = 115200, Parity = NoneData Bits = 8, Stop Bits = 1, Flow Control = XON/XOFF
• B.Baud Rate = 9600, Parity = NoneData Bits = 8, Stop Bits =1, Flow Control = XON/XOFF
• C.Baud Rate = 115200, Parity =NoneData Bits = 8, Stop Bits = 1, Flow Control = None
• D.Baud Rate = 115200, Parity = EvenData Bits = 8, Stop Bits = 1, Flow Control = XON/XOFF

A customer wants to configure a threshold alert definition. Which types of definitions can be configured?

• A.Latency, Disks, and Replication
• B.Storage, Replication, and Hardware
• C.I/O Usage, Storage, and Replication
• D.Storage, Latency, and Disks

A customer is using an SC8000 array with three chained SC220 expansion enclosures on a single card. They need to expand its capacity by adding an SC280 enclosure. How should the new expansion enclosure be connected using a minimum number of chains?

• A.Add the SC280 to the same chain as the existing SC220 enclosures
• B.Install a new SAS I/O card to connect the SC280 enclosure
• C.Add the SC280 to a new chain on the same SAS I/O card
• D.SC280 enclosures cannot be mixed with other enclosures