D-VXR-OE-23 試験問題を無料オンラインアクセス

Using the VxRail plug-in. where can iDRAC settings be configured?

• A.Cluster > Configure > VxRail > iDRAC Configuration
• B.Host > Configure > Hardware > iDRAC Configuration
• C.Cluster > Configure > VxRail > Networking
• D.Host > Configure > VxRail > iDRAC Configuration

VxRail nodes have been purchased to add additional capacity The new nodes are based on AMD Chipset, the current cluster is based on Intel Chipset What should be the next step?

• A.Enable VMware EVC Mode and then add the new nodes.
• B.A Add the new nodes to the existing cluster
• C.Create an additional Cluster with the new nodes

SIMULATION
Task
An administrator is working with the VxRail Dell Support team and as part of the troubleshooting, the admin has been instructed to temporarily remove the node with a serial number of "V0730040000000" from the cluster.
User credentials are Username of
"[email protected]"
Password "VMw@r3!123".
Using the simulator, identify the correct node and remove it from the cluster.

SIMULATION
An existing 4-node VxRail standard cluster has to be scaled out with 2 additional nodes and configured as a stretched cluster. An administrator must prepare a vSAN storage policy that should have the following:
- vSAN Policy Name: vSAN
Stretched Cluster
- Data protection across the sites
- Local protection: RAID-1 with
FTT=1
- Thick Provisioning
An administrator should be able to provision a VM even if the currently available cluster resources cannot satisfy the current policy.
Use the simulator to create the required vSAN storage policy.

What are two failure states of vSAN components? (Select 2)

• A.Inaccessible
• B.Orphaned
• C.Absent
• D.Degraded