D-UN-OE-23 試験問題を無料オンラインアクセス

A system engineer created one NAS server using NFSv4 protocol with one NFS share named AppTech1. They gave one host access but were unsuccessful in mounting the share. Where should the system engineer check to ensure that the host has proper access?

• A.File system properties
• B.NAS server properties
• C.NFS share properties
• D.Host properties

A company has an ESXi host installed with FC HBAs that is connected to a Dell Unity XT storage array. A 500 GB LUN is provisioned to this host from the Unity array and is in production. The VMware administrator has configured a new vSwitch with the NICs on the server intended for iSCSI traffic. The storage administrator is asked to configure software iSCSI and provision a new
1 TB LUN from the storage array using iSCSI.
What is a consideration when satisfying this request?

• A.Any single host should connect to any single array using one protocol only.
• B.Two iSCSI target interfaces must be configured with IP addresses from separate subnets.
• C.A connection must be established between the host iSCSI initiators and Unity iSCSI targets before provisioning the new LUN.

There are 240 snapshots that are created for a Base LUN on a Dell Unity XT array. What is the maximum number of thin clones that can be created from the Base LUN?

• A.32
• B.64
• C.8
• D.16

Refer to the exhibit. Which two MD5 authentication mechanisms does the configuration support?

• A.SSL
• B.SMTP AUTH LOGIN
• C.STARTTLS
• D.CRAM-MD5

Which SNMP versions are supported by Dell Unity XT?

• A.SNMPv1 and SNMPv3 only
• B.SNMPv2c and SNMPv3 only
• C.SNMPv1, SNMPv2c, and SNMPv3
• D.SNMPv1 and SNMPv2c only