D-PSC-MN-01 試験問題を無料オンラインアクセス

A platform engineer is tasked with adding F600 nodes to an existing Dell EMC PowerScale cluster. After racking and stacking the F600 nodes, they determine that the cluster contains X210 and H400 nodes.
What should the platform engineer consider?

• A.The cluster must be upgraded to Ethernet back-end topology
• B.H400 nodes cannot co-exist with the F600 nodes in the same cluster
• C.F600 nodes cannot co-exist with X210 nodes in the same cluster
• D.The F600 must use InfiniBand for internal network communication

Which actions are necessary to prepare a site for PowerScale hardware installation? (Select two)

• A.Arranging for specialized cooling systems
• B.Verifying the availability of adequate power sources
• C.Planning for future expansion
• D.Ensuring the floor can support the weight of the hardware

What are the required settings when using terminal emulation software to connect to a Dell EMC PowerScale Gen 5 node?

• A.Transfer Rate = 57.600, Data Bits = 8, Parity = 1, Stop Bits = 0, Flow Control = Software
• B.Transfer Rate = 115.200, Data Bits = 8, Parity = None, Stop Bits = 1, Flow Control = Hardware
• C.Transfer Rate = 115.200, Data Bits = 7, Parity = 1, Stop Bits = 1, Flow Control = Software
• D.Transfer Rate = 57.600, Data Bits = 7, Parity = 1, Stop Bits = 8, Flow Control = Hardware

A Dell PowerScale platform engineer is on site to perform a node replacement. The serial number on the tag does not match the serial number provided by the customer. The platform engineer suspects the tag is incorrect.
Which command can they run to obtain the serial number of the node?

• A.isi status -q
• B.isi_hw_status -i
• C.isi_nodes %<id> %<name>
• D.isi devices | grep SerNo

Which cable is required to connect to the A300 console?

• A.RJ45
• B.DB9-to-DB9
• C.VGA
• D.USB-to-USB