D-PEMX-DY-23 試験問題を無料オンラインアクセス

An administrator has installed the iDRAC Service Module in the OS on a compute sled, they are unable to use its features in the iDRAC web GUI.
What is the likely cause of this issue?

• A.OS to iDRAC pass-through feature is not enabled in the iDRAC
• B.iDRAC Express license is installed
• C.OS and iDRAC are configured on different networks
• D.Installed OS is not supported

An administrator is connecting two MX840c to an MX5016s. The MX5016s is configured in Enclosure Assigned mode.
What should the requirements of this mode be to avoid configuration issues?

• A.MX745P with a cluster aware OS
• B.MX745P with no OS restrictions
• C.HBA330MMZ with no OS restrictions
• D.HBA330MMZ with a cluster aware OS

A system administrator must interface the compute sleds of an MX7000 chassis to a Z9432F-ON in a single SmartFabric.
Which FEM IOM is required?

• A.MX5108n
• B.MX7116n
• C.MX9116n
• D.MX8116n

What is a characteristic of MX7000 networking in Full Switch Mode?

• A.Networking is available on MX9116n FSE and MX7116n FEM but not on the MX5108n.
• B.Networking is enabled by default and all switch-specific OS10EE capabilities are available.
• C.Switches operate as layer 2 I/O aggregation devices and are managed through OME-M.
• D.Layer 2 bridging is disabled by default and interfaces must join a bridge domain (VLAN) before being able to forward frames.

What is the connection protocol between FReD and MM?

• A.Ethernet
• B.I2C
• C.FC
• D.HDMI