DSDSC-200 試験問題を無料オンラインアクセス

What is the first sequence of commands that should be used to initialize an SC8000 system after connecting the serial cable?
A)

B)

C)

D)

E)

• A.Option A
• B.Option B
• C.Option D
• D.Option C

A customer needs to monitor then database volumes to make sure the IOPS and throughput do NOT exceed the desired hunts What should the engineer do to automate this monitoring for the database volumes?

• A.create a Threshold Query
• B.create an automated disk class report
• C.create a Threshold Definition
• D.create alert monitoring via charting tab

A deployment engineer needs to upgrade an existing dual-controller SC030 system to a dual-controller. SC8000 system. The deployment engineer needs to document the existing port configuration to prepare to start the physical upgrade
Which two steps are required to accurately document the existing port configuration?
(Choose two )

• A.Record the Hardware Serial Number (HSN). System Serial Number (SSN). arid SCOS version from each controller.
• B.Create a current controller IO Card/Port Usage table and a final controller IO Card Port usage table.
• C.Create cable labels to correlate the Starting Inventory Slot and Port to the Ending
  Inventory Slot and Port.
• D.Record the firmware version of the current controller IO Cards/Ports and final controller
  IO Cards Ports.

An engineer wants to perform a Storage Center OS ISO update, but must determine the
BMC IP address first In what two ways can the engineer determine the BMC IP address?
(Choose two )

• A.From the Dell Storage Manager Data Collector, choose the Storage Centers tab and find the BMC IP address for each controller.
• B.Do trace route from the controller command line interface to the virtual IP The second to last hop to die destination is the BMC IP address.
• C.In Dell Storage Manager client, highlight the controller under the Hardware tab and choose "Edit Setrings".
• D.From the command line interface of each controller, run "platform bmc show"

A storage administrator is setting up replication between two Storage Centers for the first time and needs to determine the proper zoning for the two systems to communicate. Both
Storage Centers are using Virtual Port mode.
Which three zones are the proper zones to set up m each fabric? (Choose three.)

• A.A single zone to include all Storage Center physical WWPNs of system B and the virtual
  WWPNs of system A
• B.A single zone to include all Storage Center physical and virtual WWPNs from system A and system B
• C.A single zone to include all Storage Center physical WWPNs of system A and the virtual
  WWPNs of system B
• D.A single zone to include all Storage Center physical WWPNs from system A and system
  B
• E.A single zone to include all Storage Center virtual WWPNs from system A and system B