DCPPE-200 試験問題を無料オンラインアクセス

An engineer is trying to use OpenManage Essentials to automate the deployment of 100 bare metal servers.
The engineer purchased the OME - Server Configuration Management license after point of sale and now has all of the licenses needed.
What is the most efficient way to install the licenses?

• A.using OpenManage Essentials
• B.using Dell License Manager
• C.using a script
• D.using CMC

An engineer configures an Alert Action in the CMC to send an email on Warning and Critical events. Chassis fan and power events are showing up as expected. Server-specific failures such as memory module failures only indicate that the server has gone into a Critical or Warning state.
What additional configuration needs to be done to be informed via email of the detailed server failure?

• A.Select Server Event under Monitored Alerts Category in CMC.
• B.Email Alert Action for Critical and Warning errors on all iDRACs.
• C.Enable Forward iDRAC events to CMC error log in iDRAC.
• D.Set Include System Event Log (SEL) option in CMC email action.

An engineer is redeploying a blade chassis, and is logged into the CMC web interface. The engineer has configured the iDRACs for the blade servers.
When the engineer tries to log into one of the iDRACs, the connection fails. The engineer can ping the CMC from the engineer's workstation but can NOT ping the iDRACs. The engineer tries to ping the iDRAC IP from the CMC itself using the diagnostic tool, but that also fails.
Which two tasks should the engineer perform?

• A.Disable firewall service on iDRAC. Confirm subnet mask configuration on iDRAC.
• B.Update DNS servers for iDRAC. Check VLAN settings on the CMC and iDRAC.
• C.Confirm subnet mask configuration on iDRAC. Check VLAN settings on the CMC and iDRAC.
• D.Enable IPv6 on the CMC and iDRAC. Disable firewall service on iDRAC.

An engineer is configuring VLT between two MXL switches. The engineer runs a show vlt brief command on one of the MXLs and receives the status shown in the exhibit. What should the engineer verify to fix the issue?

• A.Both MXLs run the same firmware version
• B.VLT cables are plugged in and have a link light
• C.MXLs can ping each other on their management IPs
• D.Both MXLs are powered on and fully booted into the OS

Refer to the exhibit.
An engineer receives a pair of the modules shown to install into a pair of MXL switches.
Which cables does the engineer need for this module?

• A.QSFP+ to QSFP+, 40GbE Passive Copper Direct Attach
• B.Cat6A Snagless Unshielded (UTP) Network Patch Cable
• C.SFP+ to SFP+, 10GbE, Copper Twinax Direct Attach
• D.OM4 MTP Crossover Fiber Cable (optics required)