Host-only mode is a network option that isolates a client-side virtual machine from the rest of the network. It allows the virtual machine to communicate only with the host machine and other virtual machines on the same host. NAT mode allows the virtual machine to share the host's IP address and access the network through it. Bridge mode allows the virtual machine to have its own IP address and connect directly to the network. Direct mode is not a valid network option for virtual machines.

Optical media, such as CDs, DVDs, or Blu-ray discs, are a suitable choice for backing up a large collection of DVDs and photos in the most economical way. Optical media are inexpensive, widely available, and have a long shelf life. They can store large amounts of data, up to 50GB on a dual-layer Blu-ray disc, and can be easily labeled and organized. Optical media are also less prone to mechanical failure, data corruption, or accidental deletion than hard disk drives (HDDs) or solid state drives (SSDs).
The other options are not as economical or suitable for this purpose. A 5,400rpm HDD is a slow and noisy type of HDD that has moving parts that can wear out or break. A HDD also consumes more power and generates more heat than an SSD. A M.2 NVMe SSD is a fast and compact type of SSD that uses a PCIe interface to transfer data. However, an SSD is more expensive than an HDD or optical media, and has a limited number of write cycles before it degrades. A SAS RAID array is a complex and costly system that uses multiple HDDs or SSDs connected by a Serial Attached SCSI (SAS) interface to provide redundancy, performance, or both. A RAID array requires a RAID controller, a compatible motherboard, and a dedicated power supply.
References:
* CompTIA A+ Certification Exam Core 1 Objectives1
* The Official CompTIA A+ Core 1 Student Guide (Exam 220-1101) eBook2
* Best ways to backup photos of 2023 | TechRadar3
* Best external hard drives in 2023: clever drives for added storage and ...4
* DVD Storage Ideas | Remodelaholic5

The company should buy Coaxial cables to be used with F-type connectors.

The correct answer is C. The battery.
The battery is the component that stores and provides electrical power to the phone. The battery can degrade over time and lose its capacity to hold a full charge. This can cause the phone to stop charging at a certain percentage and run out of power faster. To resolve this issue, the battery should be replaced with a new one that is compatible with the phone model and manufacturer.
To replace the battery, the customer may need to follow different steps depending on the type of phone and battery. Some phones have removable batteries that can be easily accessed by opening the back cover of the phone and sliding out the old battery. Other phones have non-removable batteries that are sealed inside the phone and require special tools and skills to open the phone and disconnect the old battery. In this case, the customer may need to contact the phone manufacturer or a professional service center for assistance.
Reference: Troubleshooting Mobile Devices - CompTIA A+ 220-1101 - 5.5

A blot on the screen of a smartphone is most likely caused by damage to the digitizer, which is the part of the device responsible for interpreting touch input. Improper charging is unlikely to cause a blot on the screen, as is damage to the ambient light sensor. Liquid damage is a possibility, but it is more likely to cause discoloration or other physical damage to the screen.