1Y0-A28 試験問題を無料オンラインアクセス

A network engineer needs to investigate why a few users have issues logging on to the NetScaler system. How can the engineer troubleshoot authentication issues on the NetScaler system?

• A.Use the CAT aaad.debug command.
• B.Run a violations report in Reporting.
• C.Use ECV monitoring.
• D.Check the system-authentication setting in the GUI.

A client is trying to reach a back-end server with an IP address of 10.192.31.5 given the following routing table:
Which route would the NetScaler use for this client?

• A.1
• B.5
• C.6
• D.7

Scenario: A network engineer has created two selectors to use to populate a cache group in integrated caching. One selector, "Hit," will determine what to add to the group. The other, "Inval", will select what should be invalidated. Which command should the engineer run to create the cache group?

• A.add cache contentgroup CacheGroup1 -hitParams Hit -invalParam Inval
• B.set cache contentgroup CacheGroup1 - hitParams Hit -invalParam Inval -type HTTP
• C.add cache contentgroup CacheGroup1 -hitSelector Hit -invalSelector Inval
• D.set cache contentgroup CacheGroup1 -hitSelector Hit - invalSelector Inval -type HTTP

A network engineer must determine which SSL protocols are enabled on a virtual server named SSL01.
Which command could the engineer run to see this information?

• A.Show ssl stats
• B.Show server SSL01
• C.Show ssl vserver SSL01
• D.Show vServer SSL01

Scenario: A network engineer needs to configure Citrix NetScaler to provide Access Gateway services to VLAN 2 using interface 1/1 only, while also using interface 1/2 to provide load balancing services to VLAN 3. How could this result be achieved?

• A.Disable layer 2 mode Create 2 untagged VLANs - VLAN 2 and VLAN 3 Bind VLAN 2 to Interface 1/1 Bind VLAN 3 to Interface 1/2
• B.Configure policy-based routing using the Interface option as a filter.
• C.Disable static route advertisement.
• D.Enable Layer 3 mode Create a Channel Interface using Interface 1/1 and 1/2 Create 2 VMACs Bind a VMAC to interface 1/1 and 1/2