600-601 試験問題を無料オンラインアクセス

Exhibit:

Refer to the exhibit. An industrial ruggedized network device needs to be installed in the place of the icon labeled Network Device to accommodate a leased line attachment to the Internet. Which network device and interface configuration meets the minimum requirements for this installation?

• A.a switch with one Ethernet and one serial interface
• B.a router with one Ethernet and one modem interface
• C.a router with one Ethernet and one serial interface
• D.a switch with two Ethernet interfaces
• E.a router with two Ethernet interfaces

Which two ports does EtherNet/IP use to communicate? (Choose two.)

• A.TCP 2222
• B.TCP 44818
• C.UDP 44818
• D.UDP 502
• E.TCP 502
• F.UDP 2222

An Ethernet cable is attached to a PC NIC and then attached to a switch port. The PC power is turned on and the switch port link LED turns green. The link light indicates what two conditions? (Choose two.)

• A.The PC has received a DHCP address.
• B.The switch port is functioning as a half-duplex connection.
• C.The Layer 1 media is functioning between the PC and switch.
• D.If flashing, the green LED indicates port speed of 100 Mb/s.
• E.Layer 2 communication has been established between the PC and switch.
• F.Traffic is being sent from the switch to the P

Which three of the following components must be elected before the Spanning Tree Protocol can converge in a switched LAN? (Choose three.)

• A.root ports
• B.root bridge
• C.designated ports
• D.duplex operating mode
• E.BDPU priority
• F.fast mode ports

What is a reason to use privileged EXEC mode on an industrial switch?

• A.to configure parameters that apply to the entire switch
• B.to configure VLAN parameters
• C.to change terminal settings
• D.to verify commands that you have entered