600-212 試験問題を無料オンラインアクセス

Which configuration option configures a TACACS+ server to be used for authentication on the Cisco ASR 5000?

• A.configure
  tacacs mode server priority 1 ip-address 10.10.10.10 shared-secret cisco123 exit
  aaa tacacs+
• B.configure
  tacacs mode server priority 1 ip-address 10.10.10.10 password cisco123 exit
  aaa tacacs+
• C.configure
  tacacs mode server priority 1 ip-address 10.10.10.10 service authorization password cisco123 exit
  aaa tacacs+
• D.configure
  tacacs mode server priority 5 ip-address 10.10.10.10 service authentication password cisco123 exit
  aaa tacacs+

Which two nodes exchange the create indirect data tunnel request during LTE to UMTS handover? (Choose two.)

• A.source MME to target SGW
• B.source MME to source SGW
• C.target SGSN to target SGW
• D.source MME to target SGSN

Which three options are charging characteristic selection modes for S-GW/P-GW? (Choose three.)

• A.serving node specific
• B.home default
• C.visiting default
• D.subscription specific
• E.roaming default
• F.APN specific

Refer to the exhibit.

Which two options best describe this CDR? (Choose two.)

• A.The CDR was generated due to RAT Type change to EUTRAN
• B.The CDR was generated for IMSI +91-123012345612345
• C.The CDR was generated for the home subscriber.
• D.The CDR was generated for an MS that belongs to the "cisco" APN.
• E.The CDR was generated because the volume limit was reached.

Which option describes where the Sp reference point is located?

• A.between PCRF and the application function
• B.between PCRF and SPR
• C.between PGW and trusted non-3GPP IP access
• D.between PCRF and ePDG