500-201 試験問題を無料オンラインアクセス

What are the primary functions of Cisco Prime Central?

• A.a workflow engine that can be customized with design tools
• B.a coordinator of activity among elements controlling design and analysis
• C.an operator portal only
• D.both an operator and a management portal

Why is frequency synchronization required in a mobile backhaul network?

• A.for proper phase alignment between base stations
• B.for accurate SLA measurements and billing
• C.for proper mobile device hand-off between base stations
• D.for filtering between the nodes

Which two access methods did the Cisco UMMT 3.0 solution validate? (Choose two.)

• A.Multiprotocol Label Switching Transport Profile access
• B.MPLS access
• C.TDM access
• D.Gigabit Passive Optical Network (GPON)
• E.Ethernet ring

In a Cisco UMMT deployment, which two items have an egress transport filter? (Choose two.)

• A.mobile transport gateway
• B.core route reflector
• C.aggregation node
• D.pre-aggregation node
• E.access node

You have configured your Cisco ASR 901 on the network, created a loopback interface for use with PTP, and assigned the address as a PTP source interface.
Why are you unable to ping the interface address?

• A.The loopback addresses assigned as a PTP clock source are not pingable.
• B.There is no reason for the interface to not ping; there must be a routing issue.
• C.The interface is shut down and therefore not pingable. Issue the no shut command on the interface.
• D.The loopback addresses on a Cisco ASR 901 are not pingable.