350-001 試験問題を無料オンラインアクセス

While you are troubleshooting network performance issues, you notice that a switch is periodically flooding all unicast traffic. Further investigation reveals that periodically the switch is also having spikes in CPU utilization, causing the MAC address table to be flushed and relearned. What is the most likely cause of this issue?

• A.A routing protocol that is flooding updates
• B.A corrupted switch CAM table
• C.A user that is downloading the output of the show-tech command
• D.STP is not running on the switch
• E.A flapping port that is generating BPDUs with the TCN bit set

Refer to the exhibit. Voice traffic is marked "precedence 5." How much bandwidth is allocated for voice traffic during periods of congestion?

Cisco 350-001 Exam

• A.a minimum of 48 kb/s
• B.a maximum of 48% of the available bandwidth
• C.a minimum of 48% of the available bandwidth
• D.a maximum of 48 kb/s

Refer to the exhibit. As a network administrator, you have configured a dual-rate, dual-bucket policer in accordance with RFC 2698 on the serial interface of you router, connecting to your provider. The SLA with your provider states that you should only send AF31 (limited to 150 kb/s), AF32 (limited to 50 kb/s)and AF33 (best effort). Your service provider claims you are not conforming to the SLA. Which two things are wrong with this configuration? (Choose two.)

• A.The policer is configured in the wrong class.
• B.This policer configuration is not implementing RFC 2698 dual-bucket, dual-rate.
• C.The configuration of a service policy on half-duplex Ethernet interfaces is not supported.
• D.The violate action is wrong.
• E.The class class-default sub-command of the policy-map limit command should be set to the DSCP default.

Which individual metrics can be used to calculate the composite EIGRP metric?

• A.Total delay, minimum bandwidth, reliability, load
• B.Total delay, minimum bandwidth
• C.Total delay, minimum bandwidth, reliability, load, MTU
• D.Total delay, minimum bandwidth, reliability, load, MTU, hop count
• E.Total delay, minimum bandwidth, reliability, load, hop count

Refer to the exhibit.

Cisco 350-001 Exam
Which statement would explain why R4 and R3 are unable to build an EIGRP adjacency?

• A.The network masks on R4 (209.165.202.128/27) and R3 (209.165.202.128/28) are different.
• B.R4 is not routing for the network 209.165.200.224/28.
• C.The local EIGRP process on R4 and R3 are the same (but they must be unique).
• D.The routing metrics on R4 and R3 are different.