300-730 試験問題を無料オンラインアクセス

Which redundancy protocol must be implemented for IPsec stateless failover to work?

• A.GLBP
• B.VRRP
• C.SSO
• D.HSRP

Which command shows the smart default configuration for an IPsec profile?

• A.show crypto ipsec profile default
• B.show run all crypto ipsec profile
• C.ipsec profile does not have any smart default configuration
• D.show smart-defaults ipsec profile

Refer to the exhibit. The IKEv2 site-to-site VPN tunnel between two routers is down. Based on the debug output, which type of mismatch is the problem?

• A.preshared key
• B.peer identity
• C.transform set
• D.ikev2 proposal

Which VPN solution uses TBAR?

• A.Cisco AnyConnect
• B.DMVPN
• C.VTI
• D.GETVPN

An engineer is implementing a failover solution for a FlexVPN client site where ESP traffic to the primary FlexVPN server is blocked intermittently after tunnel establishment. This issue causes users at the branch site to lose access to the corporate network. The solution must quickly establish a tunnel and send traffic to the secondary FlexVPN server only during a failover event.
Which action must the engineer take to implement this solution?

• A.Create one tunnel with peer statements to each server and use object tracking to track the status of the primary server.
• B.Create one tunnel with peer statements to each server and use Dead Peer Detection to track the status or the primary server.
• C.Create two tunnels for each FlexVPN server and use a dynamic routing protocol to track the status or each FlexVPN server.
• D.Create two tunnels for each FlexVPN server and use the tunnel keepalive command to track the status of each FlexVPN server.