300-630 試験問題を無料オンラインアクセス

Refer to the exhibit.

A network engineer configures a Layer 4 to Layer 7 device for an outside routed firewall that is connected to POD-1 inside a Cisco ACI fabric that consists of two pods. All traffic from POD-1 or POD-2 that uses the L3Out should pass through the routed firewall. Which Function Type must be implemented in the service graph for POD-2 to use L3Out?

• A.GoTo
• B.L2
• C.L1
• D.GoThrough

Where are STP BPDUs flooded in Cisco ACI fabric?

• A.in the VNID that is assigned to the FD VLAN
• B.in the access encapsulation VLAN part of different VLAN pools
• C.in the native VLAN ID
• D.in the bridge domain VLAN

An engineer created a Cisco ACI environment in which multiple tenants reuse the same contract. The requirement is to prevent inter-tenant communication. Which action meets this requirement?

• A.Create the contract in the common tenant with the scope set to Global
• B.Create the contract in the common tenant with the scope set to Tenant
• C.Create the contract in the user tenant with the scope set to VRF and exported to other tenants
• D.Create the contract in the user tenant with the scope set to Global and exported to other tenants

Which action must be taken to connect two nonsilient servers in active/standby mode to two ACI leaves?

• A.Disable dataplane learning to avoid endpoint flapping
• B.Enable ARP flooding for the bridge domain if the MAC address of the active interface changes after NIC failover
• C.Configure ARP flooding for the bridge domain if the MAC address of the active interface stays identicalafter a NIC failover
• D.Implement a virtual PortChannel on ACI leaves

Refer to the exhibit.

The 0.0.0.0/0 is configured as a default static route on L3Out-1. Which action should be taken for the 0.0.0.0/0 prefix to advertise out on L3Out-2 OSPF?

• A.Enable Shared Security Import Subnet
• B.Enable Export Route Control Subnet
• C.Enable Shared Route Control Subnet
• D.Enable Aggregate Export Subnet