300-615 試験問題を無料オンラインアクセス

Refer to the exhibit.

A blade server on UCS-1 fails to boot from SAN. The PWWNs of the server and the target device are in the fabric login database of the N9K-1. Which set of actions resolves the issue?

• A.Reset HBA adapter 1/2/1 to reinitiate FLOGI.
• B.Define LUN masking on the storage array.
• C.Set fabric binding based on the initiator PWWN and target PWWN.
• D.Configure zoning and activate the zone set.

An engineer is implementing a new BGP peering in their new data center. The engineer set up the BGP session that peers with the remote end. As soon as the BGP peers attempt to exchange routing prefixes, one of the BGP peers drops the connection. After reviewing the configuration, the engineer reviews the logging messages. The engineer discovers that the router is missing keepalives from the remote end and terminates the session. Which action resolves the issue?

• A.Set the higher values for the BGP keepalive and hold-down timers on both peers
• B.Configure the matching BGP passwords between the peers
• C.Configure the matching BGP AS numbers between the peers
• D.Set the bgp transport path-mtu-discovery attribute on both peers

Refer to the exhibit.

A Postman call to a Cisco APIC fails. The access credentials were confirmed to be configured as expected.
Which action resolves the issue?

• A.Modify the target protocol type to XML
• B.Change operation type to POST
• C.Modify the protocol to HTTP
• D.Change the IP address to a domain name

Refer to the exhibit.

An engineer troubleshoots the HSRP configuration and notes that the remote end uses HSRP version 1. The engineer sets the local HSRP to version 1, but the problem continues. Which action resolves the issue?

• A.Set the local group number as 300 in the remote data center configuration
• B.Change the local group number to 255 or less and request that the remote data center matches the group member in its configuration.
• C.Reduce the priority of the local HSRP to below 100 to force the local HSRP to standby and then change the version to version 1.
• D.Run version 1 and version 2 HSRP on VLAN300 in the local data center.

Refer to the exhibit.

After the configuration is performed, guestshell continues to use 2%CPU. Which action resolves the issue?

• A.Resync the database
• B.Recreate the guestshell
• C.Reboot the guestshell
• D.Reboot the switch