300-475 試験問題を無料オンラインアクセス

In Cisco ACI, general steps are required to create an Application Network Profile. In Cisco ACI, general steps are required to create an Application Network Profile.
Which order should the configuration be done?
1) Create connection points between EPGs by using policy constructs.
2) Create policies to define connectivity with permit, deny, log, and
so on.
3) Create EPGs.

• A.3, 2, 1
• B.1, 3, 2
• C.1, 2, 3
• D.2, 3, 1

Which two guidelines or restrictions are valid when using traceroute? (Choose two.)

• A.The traceroute source and destination IP addresses are configured as a combination of IPv4 and IPv6 addresses.
• B.Traceroute only supports endpoint-to-endpoint mode.
• C.A traceroute that is initiated from the tenant endpoints shows the default gateway as an intermediate hop that appears at the ingress leaf switch.
• D.When the traceroute source or destination is an endpoint, the endpoint must be dynamic and not static.

Which network protocol is used for Cisco ACI fabric data plane forwarding?

• A.FabricPath
• B.VXLAN
• C.MP-BGP
• D.ISIS

Service graphs and service functions have which three characteristics? (Choose three.)

• A.The service graph restricts the administrator to linear service chains.
• B.Service graph edges are directional.
• C.Service graphs can only consist of a single service appliance.
• D.Traffic can be reclassified again in the network after a service appliance emits it.
• E.Taps (hardware-based packet copy service) can be attached to different points in the service graph.
• F.Service appliances are dynamically detected and configured when added to a service graph.

Endpoints assigned to an EPG can be defined in several ways. What is an eligible attribute for this assignment?

• A.VXLAN or NVGRE
• B.VLAN
• C.VMware port group
• D.Layer 4service port