300-180 試験問題を無料オンラインアクセス

A customer is configuring an upstream disjoint Layer 2 network in a Cisco UCS domain. So far they have configured the following:
* Fabric Interconnects are in switching mode
* There is symmetrical configuration for high availability
* There are no overlapping VLANs
* Each vNIC is communicating with one disjoint Layer 2 network
After validating the above, the customer is still having issues with network connectivity. What is the issue?

• A.The fabric interconnect must be in end-host mode for a disjoint Layer 2 network
• B.Asymmetrical configuration for high availability needs to be configured
• C.Overlapping VLANs are allowed in a disjoint Layer 2 network
• D.The vNIC configuration is incorrect and must communicate with two or more disjoint layer 2 networks.

Which command would you use to check the status of your configuration synchronization peer?

• A.N5K2# show peer status
• B.N5K2# show config-sync peer
• C.N5K2# show switch-profile peer
• D.N5K2# show synch peer

Which command would you use to check the status of your configuration synchronization peer?

• A.N5K2# show peer status
• B.N5K2# show config-sync peer
• C.N5K2# show switch-profile peer
• D.N5K2# show synch peer

Refer to the exhibit.

Which action resolves the problem?

• A.Change the VSAN in which the port is located
• B.Enable F Port mode on the link to the NPV switch
• C.Disable NPIV on the switch
• D.Configure the correct FCID on the switch

Refer to the exhibit.

Which statement describes the output of the command?

• A.The ports of the host are added to the DVS on VLAN 27
• B.The VSM is connected to the vCenter server
• C.The active VSM is connected to the standby VSM
• D.The DPA interface is configured to use the incorrect VLAN