300-165 試験問題を無料オンラインアクセス

What is an Overlay Transport Virtualization extended VLAN?

• A.the user VLAN that exists in multiple sites
• B.the VLAN that must contain the overlay interface
• C.the VLAN used to access the overlay network by the join interface
• D.the VLAN used to locate other AEDs

Which feature allows routing protocols to remain in the data path during a supervisor failover?

• A.Cisco Stateful Switchover
• B.Cisco Route Processor Redundancy
• C.Cisco Express Forwarding
• D.Cisco Nonstop Forwarding

Which option is supported when configuring a VACL?

• A.Redirect to a SPAN destination port
• B.Access map entry that uses an IP or MAC ACL
• C.Egress VACL that contains decapsulated VXCLAN traffic.
• D.Log of traffic that is matched by a VACL by using a MAC ACL.

What can be identified by running the switch# show install all impact kickstart bootflash:n5000-uk9-kickstart.4.2.1.N.1.1a.bin system bootflash:n5000-uk9.4.2.1.N1.1a.bin command?

• A.whether ISSU is supported for the specified Cisco NX-OS images
• B.the impact of the specified kickstart image on the specified system image
• C.whether the specified system image supports the kickstart image
• D.whether bootflash is supported for the specified Cisco NX-OS images

A Cisco Nexus 2000 Series Fabric Extender is connected to two Cisco Nexus 5000 Series switches via a vPC link. After both Cisco Nexus 5000 Series switches lose power, only one switch is able to power back up. At this time, the Cisco Nexus 2000 Series Fabric Extender is not active and the vPC ports are unavailable to the network.
Which action will get the Cisco Nexus 2000 Series Fabric Extender active when only one Cisco Nexus 5000 Series switch is up and active?

• A.Shut down the peer link on the Cisco Nexus 5000 Series switch that is powered on.
• B.Power off and on the Cisco Nexus 2000 Series Fabric Extender so that it can detect only one Cisco Nexus 5000 Series switch at power up.
• C.Move the line from the failed Cisco Nexus 5000 Series switch to the switch that is powered on, so the port channel forms automatically on the switch that is powered on.
• D.Configure reload restore or auto-recovery reload-delay on the Cisco Nexus 5000 Series switch that is powered on.