200-150 試験問題を無料オンラインアクセス

How many layers are present in the OSI layer model versus the TCP/IP model?

• A.seven layers in OSI and four layers in TCP/IP
• B.four layers in OSI and seven layers in TCP/IP
• C.six layers in OSI and three layers in TCP/IP
• D.five layers in OSI and six layers in TCP/IP

Refer to the exhibit.

Regarding the OSI networking model and the updated TCP/IP networking model, which statement about this scenario is true?

• A.Model A is OSI, Model B is TCP/IP, Layer C is Session, Layer D is Network, and Layer E is Physical.
• B.Model A is TCP/IP, Model B is OSI, Layer C is Transport, Layer D is Internet, and Layer E is Physical.
• C.Model A is TCP/IP, Model B is OSI, Layer C is Transport, Layer D is Internet, and Layer E is Network Access.
• D.Model A is OSI, Model B is TCP/IP, Layer C is Transport, Layer D is Data Link, and Layer E is Physical.

Which description of a vFC interface is true?

• A.It can be associated to more than one VSAN.
• B.It must be bound to an FCoE-enabled Ethernet or EtherChannel interface.
• C.It can be associated to a private VLAN.
• D.It can be associated to an FCoE VLAN.

The MAC address table on a Cisco Nexus Series switch is full. What Layer 2 network behavior will occur while the network MAC address table remains full?

• A.The switch will reset the MAC address table, removing all MAC addresses.
• B.The switch will removing all dynamically learned MAC addresses from the table.
• C.All frames will be flooded.
• D.Frames with an unknown destination address will be flooded.

Which option is a characteristic of n+1 power redundancy mode?

• A.It uses fully redundant PSUs supplied by different circuit.
• B.It uses the minimum number of PSUs required to power the chassis.
• C.It uses fully redundant PSUs supplied by a single circuit.
• D.It uses one more PSU than required to power the chassis.