200-120 試験問題を無料オンラインアクセス

Refer to the exhibit.

What set of commands was configured on interface Fa0/3 to produce the given output?

• A.interface FastEthernet 0/3 channel-group 1 mode desirable switchport trunk encapsulation dot1q switchport mode trunk
• B.interface FastEthernet 0/3 channel-group 2 mode passive switchport trunk encapsulation dot1q switchport mode trunk
• C.interface FastEthernet 0/3 channel-group 2 mode active switchport trunk encapsulation dot1q switchport mode trunk
• D.interface FastEthernet 0/3 channel-group 2 mode on switchport trunk encapsulation dot1q switchport mode trunk

Refer to the exhibit.

Switch port FastEthernet 0/24 on ALSwitch1 will be used to create an IEEE 802.1Q-compliant trunk to another switch. Based on the output shown, what is the reason the trunk does not form, even though the proper cabling has been attached?

• A.The correct encapsulation type has not been configured.
• B.An IP address must be configured for the port.
• C.The "no shutdown" command has not been entered for the port.
• D.VLANs have not been created yet.
• E.The port is currently configured for access mode.

Refer to the exhibit.

A new subnet with 60 hosts has been added to the network. Which subnet address should this network use to provide enough usable addresses while wasting the fewest addresses?

• A.192.168.1.64/26
• B.192.168.1.56/26
• C.192.168.1.56/27
• D.192.168.1.64/27

Which three characteristics are representative of a link-state routing protocol? (Choose three.)

• A.provides common view of entire topology
• B.utilizes event-triggered updates
• C.utilizes frequent periodic updates
• D.exchanges routing tables with neighbors
• E.calculates shortest path

Which layer in the OSI reference model is responsible for determining the availability of the receiving program and checking to see if enough resources exist for that communication?

• A.transport
• B.presentation
• C.session
• D.application
• E.network