200-001 試験問題を無料オンラインアクセス

Refer to the exhibit.

The screenshots show outputs from the xStatus of a Cisco TelePresence endpoint and the VCS registrations. What are the protocol and direction of the call, the called party, and the transmit rate of the call?

• A.sip, outgoing, 5919*2345, 768 Kb/s
• B.h.323, outgoing, 5919*2345, 1152 Kb/s
• C.sip, incoming, 5919*2345, 768 Kb/s
• D.h.323, incoming, 5919*2345, 1152 Kb/s
• E.h.323, incoming, 5919*2345, 768 Kb/s

Your customer reports that they have had unwanted calls routing from their Cisco VCS
Expressway to their ISDN gateway. Which way is recommended to prevent these calls?

• A.Configure a Registration Allow List on the Cisco VCS Expressway.
• B.Configure a Registration Deny List on the Cisco VCS Expressway.
• C.Implement a CPL on the Cisco VCS Control.
• D.Implement a CPL on the Cisco VCS Expressway.

The Cisco Telepresence Codec C90 is unable to call the Cisco IP Video Phone. Assuming that the calling search space has been configured correctly, which of the these can cause this issue?

• A.The Cisco Telepresence Codec C90 can only be registered to a Cisco Telepresence Video Communication Server.
• B.The Cisco Telepresence Codec C90 Profile 1 > CallSetupMode must be configured as a gateway since Cisco Unified Communications Manager does not have a gatekeeper functionality.
• C.A multipoint control unit is required in order for the call to work.
• D.The Cisco Telepresence Codec C90 is not registered as a SIP endpoint on Cisco Unified Communications Manager. The Cisco Telepresence Codec C90 needs to be registered as both SIP and H.323.
• E.The Cisco Telepresence Codec C90 can only be registered as a SIP endpoint to Cisco Unified Communications Manager. H.323 is not supported.
• F.URI dialing has not been configured on Cisco Unified Communications Manager.

Which three Cisco TelePresence multipoint media conferencing platforms can utilize Cisco Unified Communications Manager for call control? (Choose three.)

• A.Cisco TelePresence SX20
• B.Cisco TelePresence Multipoint Switch
• C.Cisco TelePresence Multipoint Control Unit
• D.Cisco TelePresence Server
• E.Cisco TelePresence System 500-32
• F.Cisco TelePresence Media Bridge Server

You are troubleshooting an issue and you need to connect to presentation codec via CLI. Which CLI command allows you to connect to the presentation codec?

• A.utils presentation connect
• B.utils connect presentation
• C.utils system presentation
• D.set system presentation
• E.utils presentation system