156-581 試験問題を無料オンラインアクセス

The Check Point FW Monitor tool captures and analyzes incoming packets at multiple points in the traffic inspections. Which of the following is the correct inspection flow for traffic?

• A.(i) - pre-inbound, (I)- post-inbound, (o) - pre-outbound. (O) - post-outbound
• B.(o) - pre-outbound, (0)- post-inbound, (i) - pre-inbound, (I) - post-inbound
• C.(I) - pre-inbound, (i)- post-inbound, (0) - pre-outbound, (o) - post-outbound
• D.(0) - post-outbound, (o)- pre-outbound, (I) - post-inbound. (i) - pre-inbound

Which of the following is the most significant impact of not having a valid Policy Management license installed on a management server?

• A.Inability to review logs
• B.Inability to make rule changes
• C.Inability to install policies
• D.Inability to log in to SmartConsole

Which of the following is true about tcpdump?

• A.The tcpdump can only capture TCP packets and not UDP packets
• B.The tcpdump has to be run from Cish mode in Gaia
• C.A tcpdump session can be initiated from the SmartConsole
• D.Running tcpdump without the correct switches will negatively impact the performance of the Firewall

In the SmartConsole logs, you are seeing messages reporting NAT port exhaustion.
What command would you use to check the status of the NAT table?

• A.fw tab -t nat_alloc
• B.fw tab -t fwx_alloc
• C.fw tab -t xftrc_allo
• D.fw tab -t xlate_alloc

What would be the most likely response when attempting to use SmartConsole to connect to a management server with the wrong credentials?

• A."Incorrect name or IP address"
• B."Server down on unresponsive"
• C."invalid username or password"
• D."Authentication to server failed"