156-215.13 試験問題を無料オンラインアクセス

What happens if you select Web Server in the dialog box?

• A.Web Intelligence will be applied to the host.
• B.An implied rule will be added allowing HTTP request from and to the host.
• C.An implied rule will be added allowing HTTP requests to the host.
• D.Anti-virus settings will be applied to the host.

The London Security Gateway Administrator has just installed the Security Gateway and Management Server. He has not changed any default settings. As he tries to configure the Gateway, he is unable to connect. Which troubleshooting suggestion will NOT help him?

• A.Test the IP address assignment and routing settings of the Security Management Server, Gateway, and console client.
• B.Check if some intermediate network device has a wrong routing table entry, VLAN assignment, duplex-mismatch, or trunk issue.
• C.Verify that the Rule Base explicitly allows management connections.
• D.Verify the SIC initialization.

Where can an administrator configure the notification action in the event of a policy install time change?

• A.SmartView Monitor > Gateway Status > System Information > Thresholds
• B.SmartDashboard > Policy Package Manager
• C.SmartDashboard > Security Gateway Object > Advanced Properties Tab
• D.SmartView Monitor > Gateways > Thresholds Settings

Central license management allows a Security Administrator to perform which of the following functions?
1.Check for expired licenses.
2.Sort licenses and view license properties.
3.Attach both R76 Central and Local licesnes to a remote module.
4.Delete both R76 Local Licenses and Central licenses from a remote module.
5.Add or remove a license to or from the license repository.
6.Attach and/or delete only R76 Central licenses to a remote module (not Local licenses).

• A.1, 2, 5, & 6
• B.2, 3, 4, & 5
• C.2, 5, & 6
• D.1, 2, 3, 4, & 5

You just installed a new Web server in the DMZ that must be reachable from the Internet. You create a manual Static NAT rule as follows:

"web_public_IP" is the node object that represents the new Web server's public IP address. "web_private_IP" is the node object that represents the new Web site's private IP address. You enable all settings from Global Properties > NAT.
When you try to browse the Web server from the Internet you see the error "page cannot be displayed". Which of the following is NOT a possible reason?

• A.There is no Security Policy defined that allows HTTP traffic to the protected Web server.
• B.There is no route defined on the Security Gateway for the public IP address to the Web server's private IP address.
• C.There is no ARP table entry for the protected Web server's public IP address.
• D.There is no NAT rule translating the source IP address of packets coming from the protected Web server.