CWDP-302 試験問題を無料オンラインアクセス

When you see the SKINNY protocol in a post-install validation protocol capture, what does this indicate?

• A.VoIP is used on the network
• B.Multicasting is used on the network
• C.Secure FTP is in use
• D.HTTPS is in use

Which definition correctly describes the "local MAC" variation of the centralized WLAN architecture?

• A.All RF-, data-, and control-related WLAN functions are performed by the AP. APs coordinate network services with one another and are managed by a WNMS, so no WLAN controller is used in this architecture.
• B.All MAC functions are performed by the AP. A minimal subset of network control is offloaded to the WLAN controller along with management and monitoring functions.
• C.PHY functions are performed directly by the AP. MAC functions are divided almost equally between the WLAN controller and the AP, according to the time sensitivity of the feature or service.
• D.The AP provides the RF termination point for the WLAN, but performs very few of the WLAN functions or services. The WLAN controller performs all MAC functions and the AP is very simple and lightweight.

You are implementing an outdoor client access WLAN. It will serve employees and guests. It must cover an area of approximately 100 meters by 60 meters. You expect to support only 10-15 clients connected at a time.
What kind of antennas are likely to be used in this situation assuming two APs have been chosen for the implementation?

• A.Omni-directional
• B.Semi-directional
• C.Sectorized
• D.Highly directional

You have discovered three coverage holes during WLAN validation testing. All three exist on the same floor.
Which one of the following is the best solution for coverage hole removal while not reducing the overall capacity of the WLAN?

• A.Remove one or more APs
• B.Add one or more APS
• C.Increase the output power of the radio in all APs
• D.Decrease the output power of the client devices

When defining the required number of Aps which one of the following will have the greatest impact?

• A.Square footage in the facility.
• B.Ceiling heights in the facility.
• C.Number of clients and the applications they run.
• D.Number of clients and the antenna types they use.