150-810 試験問題を無料オンラインアクセス

You are currently implementing an FCoE platform in a DCB environment in a shared network data center.The FCoE traffic will be used only for development purposes.You want to ensure that the FCoE traffic does not block the production traffic.Which two technologies are required to implement this? (Choose two)

• A.ETS
• B.LLDP
• C.ACL
• D.DSCP

You notice dropped packets from a host connected to your Brocade VCS fabric.The host is using jumbo frames with an MTU of 9000.The MTU on the interface is also configured for 9000.With regards to the MTU, what should be done to eliminate the dropped packets?

• A.The MTU on both the host and interface MTU should be changed to 9100.
• B.The MTU on the host should be 9000; the interface MTU should be 9100.
• C.The MTU on the host should remain the same and the MTU configuration should be removed from the interface.
• D.The MTU on the host should be 9100; the interface MTU should be 9000.

You want to enable a Brocade VDX switch to form an OSPF neighbor relationship with a Brocade MLXe.Which two types of interfaces must be explicitly configured on the VDX? (Choose two)

• A.vlan
• B.ve
• C.port-channel
• D.switchport

You have a new Brocade VCS fabric.You are asked to integrate the fabric to an existing traditional network that uses DSCP.No QoS configuration changes have been made.
Which statement is correct in relation to ingress traffic into the fabric?

• A.AII DSCP values are re-mapped to DSCP 0.
• B.AII DSCP values are removed from the VLAN tag. CAN DSCP values are mapped to CoS 0.
• C.All DSCP values are ignored.

Your VCS fabric has several new Brocade VDX switches running NOS v3.0.You want to be proactively notified of any thresholds and alerts pertaining to switch hardware.Which two
Brocade products would you configure? (Choose two)

• A.Fabric Watch
• B.Brocade Network Advisor
• C.SAN Health
• D.NET Health