7220X 試験問題を無料オンラインアクセス

A customer reports that when they make a call from an H.323 endpoint at the Main office to an H.323 telephone at the Branch office across the WAN, the call fails due to codec mismatch.
If misconfigured, which three Avaya Aura Communication Manager (CM) System Administration Terminal (SAT) forms can be causing this problem? (Choose three.)

• A.ip-network-region
• B.ip-network-map
• C.ip-services
• D.node-names ip
• E.ip-codec-set

After completing Discipline 2 - Describe the Problem of the 8D Troubleshooting Methodology, what is the next discipline to be completed?

• A.Discipline 3 - Prevent Recurrences
• B.Discipline 3 - Implement Corrective Actions
• C.Discipline 3 - Develop Interim Containment Actions
• D.Discipline 3 - Implement a Work-around

A customer has just added a CS1000 SIP Entity and Entity Link using TLS port 5061. Users are unable to call any Avaya Aura users which are connected via the same Avaya Aura Session Manager (SM).
They have run a traceSM and see no SIP messages coming from the CS1000 in the trace. They can ping between the CS1000 and SM100.
Which two traces or logs are most relevant to debugging this problem and should be included in the trouble ticket raised with Tier 3 support? (Choose two.)

• A.the latest /var/log/ecslogfile on Avaya Aura Communication Manager
• B."list trace tac xxx", where xxx is the TAC of the trunk group between Avaya Aura Communication Manager and SM
• C."tshark -i eth1 -w <capturefilename>" on SM
• D.the ppm.log in /var/log/Avaya/jboss/SessionManager on SM
• E.traceSM with TLS handshaking enabled on SM

What is the purpose of a Virtual (Intervening) Network Region?

• A.To provide temporary overflow bandwidth when the direct allocation of bandwidth between connected Network Regions is not available
• B.To allow one Network Region to temporarily use bandwidth allocated to another Network Region if it runs out of bandwidth
• C.To simplify bandwidth management between Network Regions connected via a WAN
• D.To allow Inter-Gateway Alternate Routing (IGAR)

When does Communication Manager insert the shortcut flag during call processing?

• A.during the origination phase (imsorig) of call processing
• B.during the dialing analysis phase (imsdialana) of call processing
• C.during the initialization phase (imsinit) of call processing
• D.during the termination phase (imsterm) of call processing