7004-1 試験問題を無料オンラインアクセス

Click the Exhibit button.

A customer requires that two of its employees be able to place toll calls to Australia, while all other employees are restricted to local dialing only. The customer's Communication Server 1000 is programmed with all required NCOS, FRL and Route List Index (RLI).
What is the most restrictive NCOS to assign to the two employees required to make toll call Australia given the tables, assuming that the call must complete over RLI 2 and the user must be able to use any RLI 2 entry to reach Australia?

• A.NCOS 2
• B.NCOS 3
• C.NCOS 4
• D.NCOS 5
• E.NCOS 1

Given the following network characteristics:
three Communication Server 1000 RIs. 7 x systems IP Peer Networking required DN uniqueness cannot be maintained route calls using site Location Codes (LOCs)
Which type of dialing plan is recommended for this call routing scenario?

• A.Coordinated Dialing Plan (CDP)
• B.Flexible Numbering Plan (FNP)
• C.Uniform Dialing Plan (UDP)
• D.Network Attendant Numbering Plan

Click the Exhibit button.

You are asked to review the existing route information for the customer.
According to the printout shown in the exhibit, which type of route is this?

• A.a direct inward dial route
• B.a media services route
• C.an incoming only route
• D.an integrated services digital network route

Click the Exhibit button. %

You are asked to review the existing trunk information for your customer.
According to the Element Manager screen capture shown in the exhibit, which type of trunk is this?

• A.Recorder Announcement
• B.Direct Inward Dial
• C.Central Office Trunk
• D.Virtual Trunk

Your customer has a Communication Server 1000 RIs. 7 x system equipped with System Errors and Events Lookup pack 245 that provides the ability to display system messages on screen.
When a system message in received, which procedure should you use to look it up and display it on the screen?

• A.Enter errcde followed by the system error code and <cr>. For example, errcde bug4080<cr>
• B.Enter err followed by the system error code followed by <cr>. For example, err bug4080<cr>
• C.Enter bug followed by the system error code and <cr>. For example, bugerr4080<cr>
• D.Enter the system error number followed by <cr> For example, bug4080<cr>