6101.1 試験問題を無料オンラインアクセス

When configuring Ethernet Routing Switch (ERS) 8600 using the default interface, the attempt to load an ACLI configuration fails because the default interface is the CLI.
How is the ACLI interface obtained?

• A.exits the CLI and chooses ACLI at the interface manager prompt.
• B.Change the interface type in the config.cfg file.
• C.Change the ACLI boot flag and save the boot configuration file.
• D.Use the abort command and enter "no" at the default interface prompt

After issuing a show mlt list stats (CLI) or show ist Stat (ACLI) command, it is determined that the running type is normal MLT and not 1ST
What are two causes of the IST not running properly? (Choose two)

• A.The peer IP addresses have to be 192.168.1.1/30 and 192.168.1.2/30.
• B.The MLT ID does not match on both switches.
• C.The IST is not enabled on both switches.
• D.The peer IP address is not the address of the peer switch IST VLAN.

A split multi link trunking (SMLT) for switch clustering is being configured.
Which statement is a configuration requirement for the SMLT?

• A.CP-limit is configured on edge switch stacks
• B.Alternate the primary path of the SMLT connection to load balance the switch core
• C.VLANs that are defied on the SMLT are also defined on the MLT that defines the core IST
• D.Neighboring edge switch stacks should be connected to each other via DMLT connection to add resilient paths in the event of an SMLT failure

The attempt to manage an Ethernet Routing Switch (ERS) 8600 using a VRRP address was unsuccessful. What is causing this problem?

• A.The fie virtual router identifier is 0.
• B.A real IP address is required for management access not a VRRP address.
• C.The datacenter interface is set as a critical IP interface.
• D.The incorrect MAC offset is configured for the VRRP address.

A technician is adding the Virtual Link Aggregation Control Protocol (VLACP) configuration ID a Converged Campus Solution where all Ethernet Routing switches (ERSs) are directly connected without intermediary WAN transport devices
What are two key configuration tasks? (Choose two)

• A.For the SMLT links, configure the long timeout value
• B.For the 1ST links, configure the long timeout value
• C.Configure all links to use a unique reserved multicast MAC address for VLACP messages
• D.configure all links to use the default multicast MAC address for VLACP messages