3605 試験問題を無料オンラインアクセス

Consider the fallowing port conditions on an Ethernet Routing Switch (ERS)
8648GTRS 10/100/1000 Ethernet I/O module left
LED -green Right LED -
flashing green. What is the status of the port?

• A.The link speed is 100 Mbps. and the port is passing traffic.
• B.The link speed is 1000 Mbps, and the port is disabled
• C.The link speed is 1000 Mbps. and the port is passing traffic.
• D.The link speed is 100 Mbps. and the port is disabled.

A technician has implemented RSMLT edge design. After recovering from power outage some clients could not communicate. It has been stated that only one of the core RSMLT switches has recovered. What should have been done to prevent the loss of communications?

• A.Set the VLAN to copy RSMLT into from a similarity configured VLAN.
• B.Clear the peer IP and MAC addresses.
• C.Increase the hold up timer to 9999.
• D.Turn off the hold down timer.

An Ethernet Routing Switch
(ERS) 5000 Series
Release
6.2 Is installed in environment.

TO UPGRADE TO A version that includes new features, which statement about licenses is true?

• A.The features designated to the license level are available as soon as the upgrade is completed.
• B.Remove the old license from the switch and load a new license file
• C.Automatic Unit Replacement (AUR) automatically updates software feature license for
  any replacement stack unit, except the base unit.
• D.licenses are associated with software releases, not license feature levels.

A customer has purchased some Ethernet Routing Switch (ERS) 5600 switches
must integrate two ERS 5600 units into existing stack of ERS 5500 switches.
What is the procedure for the integration of the new ERS 5600?

• A.With power applied to the stack, integrate one ERS into the stack as non base unit in mixed
  stack operational
  mode.
  After the two ERS
  5600 units have obtained their configuration from the ERS 5500 base unit, change the ERS 5500 to "non base unit" and set one ERS 5600 to "base unit". Reboot the switch stack.
• B.with power applied to the slack, change the existing ERS 5500 base unit to "Non Base Unit" in mixed stack operation Integrate the two new ERS 5600 to the stack with them set as "Base Unit" in mixed stack operation Reboot the stack.
• C.Remove the AC from the stack, integrate the two ERS 5600 units into the existing 5600 set to "base unit" and one ERS 5600 set to "non base unit" set the existing ERS 5500 base unit to "non base unit" apply power to stack.
• D.With power applied to the stack, integrate one ERS into the stack as non base unit in mixed stack operational mode. Change the existing ERS 5500 base unit to "non base unit" and set the new 5600 to "base unit". Reboot the stack integrate the second ERS 5600 in mixed stack operational mode.

Simple Loop Prevention Protocol (SLPP) detects VLAN based network loops.
Which two statements about SLPP functionality are correct? (Choose two.)