132-S-911.3 試験問題を無料オンラインアクセス

When analyzing a packet capture, where do you look to verify that DiffServ Code Point (DSCP) values are being set correctly by the host?

• A.in the packet payload
• B.in the 802.1Q header
• C.in the IP header
• D.in the priority bits

When installing the G250, which two Media Modules can be placed in slot V2? (Choose two.)

• A.MM340
• B.MM720
• C.MM342
• D.MM711

What three settings need to be configured on a Layer 2 device? (Choose three.)

• A.port speed
• B.RIP
• C.routing interface
• D.IP address
• E.default gateway

You are required to configure more than 300 IP addresses. Which IP address, subnet mask, and gateway combination is valid?

• A.(address) 192.168.10.5 / (subnet) 255.255.255.0 / (default gateway) 192.168.11.254
• B.(address) 192.168.10.5 / (subnet) 255.255.255.128 / (default gateway) 192.168.10.254
• C.(address) 192.168.10.5 / (subnet) 255.255.255.0 / (default gateway) 192.168.10.0
• D.(address) 192.168.10.5 / (subnet) 255.255.253.0 / (default gateway) 192.168.11.254

A Media Gateway G450 installed on a customer site needs to be replaced because of a faulty fan unit. What is the most sensible approach?

• A.Stop the fan using the "stop fan" command in the Command Line Interface (CLI). Replace the fan unit. Start the new fan unit using the "start fan" command.
• B.The fan unit cannot be replaced on site. The whole G450 Media Gateway needs to be sent for repair.
• C.The fan unit can be exchanged in operation without interrupting service. The replacement must be made within a minute of removing the faulty unit.
• D.Make sure you disconnect power to the system. Replace the fan unit. Reconnect the power to the system.