132-S-911-3 試験問題を無料オンラインアクセス

Which Avaya Communication Manager command shows the media module firmware on all gateways?

• A.display media-gateway all
• B.list configuration all
• C.show mg list
• D.list configuration media-gateway <number>

Your customer is installing an S8300 media server as an internal Call Controller in a G700 Media Gateway. Within the gateway, a MM312 has been included for DCP telephones and a MM711 for analog telephones. The customer intends to connect 18 IP telephones. What hardware would you recommend for IP telephony connectivity?

• A.a MM314 LAN module
• B.a MM316 LAN Media Module
• C.a MM760 VoIP engine
• D.a Power Over Ethernet switch

You are concerned about potential network problems affecting a TN799DP (CLAN) circuit pack and want to check the interface for errors. Which two commands give error counts on the TN799DP circuit pack? (Choose two.)

• A.getethernet <board location>
• B.status link
• C.list measurements clan sockets <board location>
• D.list measurements clanethernet <board location>

When analyzing a packet capture, where do you look to verify that DiffServ Code Point (DSCP) values are being set correctly by the host?

• A.in the IP header
• B.in the 802.1Q header
• C.in the packet payload
• D.in the priority bits

A customer is having a poor voice quality in their VoIP deployment. Upon Avaya's recommendation, the customer uses the VoIP Monitoring Manager to measure one-way network delay between endpoints. What are three guidelines for the delay measurements? (Choose three.)

• A.80 ms delay or less can yield the best quality
• B.delay over 180 ms could be acceptable depending on customer expectations, analog trunks used, codec type, etc.
• C.delay over 250 ms causes "talk over" problems
• D.ITU spec should be 250 ms or less