CPIM-BSCM 試験問題を無料オンラインアクセス

Which of the following systems typically involves design while manufacturing is occurring?

• A.Project
• B.Engineer
• C.Flow
• D.Intermittent

An extreme change in demand in the supply position upstream generated by a small change in demand
downstream in the supply chain is called the:

• A.efficiency variance.
• B.estimate of error.
• C.bullwhip effect.
• D.stockout probability.

Service parts needs are most often determined by:

• A.forecasts based on prior demand.
• B.material requirements planning (MRP) logic calculations.
• C.analysis of lead-time requirements.
• D.bills of material explosion.

A manufacturer needs to monitor and balance the flow of work between work centers. Which of the
following techniques would address this need?

• A.Critical ratio
• B.Dispatching
• C.Drum-buffer-rope
• D.Input/output control

Reducing set up time will affect item lead time and throughput in which of the following ways?

• A.Lead time will increase, throughput will increase
• B.Lead time will increase, throughput will decrease
• C.Lead time will decrease, throughput will increase
• D.Lead time will decrease, throughput will decrease